Hand Metal Markers and Accessories

Choose a Hand Marker or Carbon Marker and Accessories to Ensure the Best Marks Possible.

One of the most important things to remember in electrochemical marking is to use the proper marking tool for the job.

Learn more about hand markers here…

Universal Cord Set

Black and red cord leads that connect the power unit to the marker and the ground plate.
4309-BA-Universal Cord Set

Marker Cartridge

Highly conductive graphite head can be milled to any special size. Includes clear plastic body that holds electrolyte.
4600-Round Marker Cartridge
Standard Sizes: 3/8, ½, ¾, 1” Blank Cap to fit included.
4650-Rectangular Marking Cartridge
Standard Size: ½ x 1 ½” Blank Cap to fit is included.

Deep Etch Pads

Heavy duty extra absorbent pads used mainly for deep etching. Used with graphite marking cartridge.
3121-3D-Deep Etch Pads

Polar Pads

Rectangular marking polar pads for use with graphite markers.
4650-1-To Fit 4650 Marker Cartridge
3121-3-Heavy Duty Polar Pads to Fit the 4650 Marker

Hand Marker Screens

Perforated screen wrapped with electrolyte absorbing paper. To be used with hand markers.
4392-1 4396-1 4397-1
Used with the Corresponding Hand Markers.

Hand Markers

Plastic body marker used in conjunction with a hand marker Hand Markers screen. Good for hard to reach places. Different sizes available.
4392-1 x 2
4395- ½ x ¾
4396- ¼ x 1 ½
4397- ½ x 1 ½

Saddle Marker

Marks round parts from a diameter of ½" to 3". Width of Marker: 1". Screen to fit is included.
16062-Saddle Marker
16062-1-Saddle Marker Screen

Electrolyte Dispensing Vessel

This unit is primarily used with our automatic marking system. It eliminates hand dipping marker cartridge and provides constant flow of electrolyte to the marker.
5700-Electrolyte Dispensing Vessel

Note:
All cases of rusting or corrosion after marking can be traced back to poor cleaning techniques. Be sure cleaning applicator does not become contaminated with electrolyte. Parts must be thoroughly dried after cleaning.

Wiping Tissue

Saturated with neutralyte, use to wipe parts after marking and neutralizing. To aid in preventing rust. Work is then ready for oiling.
2500-Wiping Tissue, 250 per package

Neutralyte Well Assembly

Marked parts are neutralized by wiping over top of block. Well must be filled with neutralyte.
4360-Neutralyte Well Assembly

Contour Block Well Assembly

Solid graphite block in an electrolyte well. Block can be contoured to almost any round part.
3200-Contour Block Well Assembly
3200-1-Polar pad and wick to fit contour block
4359-Cord set for use with contour block, 2 male ends (not shown)

Rocker Marker Assembly

For use with the grid marking assembly. Aids in the marking of large areas. Screen and wick included.
15018-Rocker Marker
15018-1&2 Rocker Screen and Wick

Roller Marker

Graphite roller marker ideal for larger area marks up to and including grid marking. Use the roller marker as you would a paint roller. Different sizes available:
1 ½”, 3”, 6”. Pad to fit included.
4394-Roller Marker
4394-1 Roller Marker Pad